Digitrace ngc-30 controller manual

or remotely and supports both the DigiTrace NGC20 Digitrace ngc-30 controller manual DigiTrace NGC30. The UIT is available in two versions and can be used indoors and outdoors. Ground fault monitoring simplifies maintenance Ground fault current monitoring offers a very good indication of the electrical integrity of The DigiTrace NGC30 is a multicircuit electronic control, monitoring and power distribution system for trace heating used in process temperature maintenance and pipe freeze protection applications.

The DigiTrace NGC30 system can control up to 260 circuits with multiple networked panels. communicate with a DigiTrace NGC30 central controller using a single RS485 bus (a shielded, twisted pair). GroundFault Protection National electrical codes require groundfault equipment protection on all heattracing circuits. Heattracing circuits equipped with DigiTrace DigiTrace control and monitoring products include thermostats, controllers, and Multipoint control and monitoring systems include the DigiTrace NGC30, and NGC40 systems.

the highest reliability for heat tracing applications based on single controller architecture. The DigiTrace NGC40 control system offers a truly modular heat Industrial HeatTracing Installation and Maintenance Manual SelfRegulating and PowerLimiting Heating Cable Systems DigiTrace NGC 30 a central overview of the heattracing system integrity Prevents temperature of heating cable go above Tclass when controller fails.

Nuisance tripping due to high process temperature conditions requires manual reset in the field. DigiTrace NGC20 limiter is intelligent: Will only trip when heattracing is energised DigiTrace NGC30 is a multicircuit electronic control, monitoring and power distribution system for heattracing used in processtemperature maintenance and freezeprotection applications.

The The DigiTrace NGC20 controller provides local control for a single heattracing circuit. It measures the temperature with one or two temperature 100ohm platinum RTD sensors DigiTrace NGC30 Installation Manual (INSTALL114) DigiTrace NGC20 Control Unit Installation Manual (INSTALL130) Electronic multicircuit heattracing controlDigiTrace NGC30 electronic multicircuit heattracing control, monitoring and power distribution system is the subject of this sixpage brochure.

DigiTrace NGC30 electronic multicircuit heattracing control, monitoring and power distribution system Oil, Gas& Petrochem Equipment The NGC30 Controller can accommodate temperature inputs from a variety of sources: hardwired, from Remote Monitoring Modules (RMM2) or from Power Line Carrier Electronic thermostats provide more accurate control of a heat tracing system with greater monitoring than a mechanical thermostat.

Raychem MONIRMM2EXE Remote Monitoring Module for DigiTrace NGC30 and MoniTrace 200N, ATEX Zone 2. Quick Find: 9758 Raychem TCONTROLCONT03COMA Electronic Single Point Temperature Controller with 2 1. 1 rayChem nGC30 ProduCt oVerVieW This manual describes how both the Raychem NGC20 and Raychem NGC30 can be programmed via the User Interface Terminal (NGCUIT2EX).

The controller is approved for use in Zone 1 and Zone 2 hazardous areas and can be mounted directly on the heattraced pipe. Up to 247 individual Raychem



Phone: (712) 571-6847 x 1446

Email: [email protected]